Installation Guide

Installation of the signal booster is quick and easy. We like to keep things simple, so all of our products follow the same logical setup procedure.

Follow these simple steps:

Step 1: Set up the outdoor antenna at the place where you have the best signal (aim for as high as possible and, if you can, direct the antenna towards the nearest cell tower for your network).

Step 2: Use the cable to connect the outdoor antenna to the repeater.

Step 3: Connect the indoor whip Omni ceiling or wall antenna directly to the repeater.

Step 4: Plug the repeater into the power supply. The repeater should immediately begin amplifying your signal, giving you 5 bars.

Installation Tips

If your signal at ground level is only 1-2 bars after installation, it may be that your outdoor antenna is too low and you need to move it to a higher place (such as the roof). It is recommended that the antenna is positioned 3-5 metres above the ground, as shown in the photo below.

installation

ATTENTION – Never plug the repeater into the power supply before you confirmed that the antenna and cable are connected! Doing so may result in damage to the repeater.

Minimum and maximum cable length (in metres) from the outdoor antenna to the repeater:

100 sq. m. repeater Min 8 / Max 20
150 sq. m. repeater Min 8 / Max 25
300 sq. m. repeater Min 8 / Max 25
600 sq. m. repeater Min 8 / Max 30
1000 sq. m. repeater Min 8 / Max 30
1500 sq. m. repeater Min 8 / Max 60

Minimum and maximum cable length (in metres) from repeater to indoor  antenna:

100 sq. m. repeater Min 3 / Max 10
150 sq. m. repeater Min 3 / Max 15
300 sq. m. repeater Min 3 / Max 15
600 sq. m. repeater Min 3 / Max 30
1000 sq. m. repeater Min 3 / Max 30
1500 sq. m. repeater Min 3 / Max 60